RTB
CMS server is equipped with the RTB server function, supported by an external HDMI video capture card. In RTB SERVER page, you can assign each media input to a particular channel and add/edit streaming clients.
 |
- Input: Choose the live signal input.
- Service State: Turn on (Enable) or Turn off (Disable) this function and input.
- Channel: Select a channel for which UDP port will be used.
- Capture card: You can adjust related parameters based on the capture card you choose.
Pixel Format Select a resolution and frame rate. Brightness To adjust the brightness from 0 to 100 by every 5 degrees. Contrast To adjust the contrast from 0 to 100 by every 5 degrees. Saturation To adjust the saturation from 0 to 100 by every 5 degrees. Hue To adjust hue from 0 to 100 by every 1 degree. Gamma To adjust gamma from 0 to 100 by every 1 degree. Sharpness To adjust the sharpness from 0 to 100 by every 1 degree. TV Standard (for analog capture card only) Set video input type. The input type can be NTSC, PAL and SECAM. Video Input Set a video input source. The input source can be Composite or S-Video. - Streaming settings:
Format You can choose either MPEG-2 or MPEG-4 (ISO) as streaming format. Broadcast All clients in the network area will receive streaming contents. Multicast Enable multicast and send streaming packets to those players which have enabled this function. Multicasting IP address ranges between 224.0.0.1 and 239.255.255.255. Unicast Click 
to add unicast client. Send signals to the player with the particular IP address. To add a unicast client, please enter a client's name and its IP address, and click Add. This item will be added to the "Unicast" table. To delete the existing client in the table, please locate the item and click 
in the command column. NoteWe would suggest you not to use broadcast and unicast at the same time.
Note |
|---|
Regarding "Please contact your dealer or CAYIN Technology for buying this option." Message. There are two possibilities that you will see this message on webpage:
|